RC Column Design (ACI318) - How is the c/dt ratio calculated?

Tekla Tedds
2021
Tekla Tedds Tekla Tedds for Word
2020
Tekla Tedds Tekla Tedds for Word
2019
Tekla Tedds Tekla Tedds for Word
2018
Tekla Tedds Tekla Tedds for Word
2022
Tekla Tedds Tekla Tedds for Word
2023
Tekla Tedds Tekla Tedds for Word
2024
Tekla Tedds Tekla Tedds for Word
Environment
USA

The variable r is used to denote the ratio of c/d_{t} where c is the depth of neutral axis from extreme compression face and d_{t} is the depth of tension reinforcement. The calculation starts by making an assumption about the value of r and performs an iteration until it manages to balance the calculated and required eccentricities. The method is explained in more detail in "Reinforced concrete" by Edward G Nawy.

Since it is an iteration, it does not show up in an equation as normally expected.

 

Was this helpful?