Dialog boxes on multiple monitors keep repositioning themselves after each save

Tekla Structures
Not version-specific
Tekla Structures
AMD
ATI
graphics card
reposition dialogs
Environment
Not environment-specific

Question:
I am using multiple monitors, but the dialog boxes keep repositioning themselves after each save. This also happens if I set my far left monitor as my primary monitor. Resetting registry did not help either. Can you suggest a solution?

 

Answer:
This kind of issue has been reported only by users who use AMD (former ATI) architecture graphic cards. If you are using AMD’s graphic card, there are some settings you can try to adjust.

Open the HydraVision tab under graphic card's "Engine Control Center", go to the Desktop Manager selection and deselect "Enable Dialog Repositioning". Depending on the AMD graphic drivers that are installed, “Catalyst Control Center” may need to be opened to find these menus to disable the "Enable Dialog Repositioning" feature.

 

Image
TUA_12_picture1.png


See also:
Selecting the correct graphics card for Tekla Structures

Was this helpful?